Updated January 10, 2023

Multi-Manufacturer Modern LMP (Long Can)

WNR CLUB BASED RULES

  Multi Manufacture Modern LMP (long can) (WNR club based rules – updated 01/10/23):

General – Multi manufacture modern day LMP cars as raced in the various endurance races around the world from 1999 to present day utilizing a plastic chassis and any non-high downforce FC-130, Flat6, and/or FK-180 motors up to 22k.

Cars

ArrowSlot - BMW V12

Avant Slot - Audi R10 TDI, Lotus Elise, Pescarolo, Peugeot 908 TDI, Porsche RS Spyder

Carrera - Audi R8, Audi R10, Audi R18 e-tron, Bentley EXP Speed 8, BMW V12 LMR, Panoz LMP, Porsche RS Spyder

Fly - “racing” and “non-racing” versions of the Lola B98/10,Panoz LMP-1

Ninco - Acura LMP2 XM, Audi R18 e-tron, BMW V12

NSR - Audi R18 TDI LMP1

Scaleauto - Radical SR9 LMP, Toyota One

Scalextric - Aston Martin (Lola) LMP 1, Audi R10, Cadillac Northstar LMP, Lister Storm LMP, MG Lola LMP, Peugeot 908 HDI, Porsche RS Spyder

SCX - Audi R8, Audi R10 TDI, Cadillac Northstar LMP, Dome-Judd (S101), Ferrari 333SP, Peugeot 908 HDI

Sloter - Zytek; Sloting Plus - Reynard 2KQ

Slot.it - Audi R8C, Audi R8 LMP, Audi R18 TDI, Lola Aston Martin DBR1-2, Lola B9/60, Lola B10/60, Lola B11/80, Lola B12/69 EV, Lola B12/80

Spirit - Courage, Dallara, Lola, Reynard

SRC – Porsche 919, Toyota LMP1

(Note: The above lists of cars are those that are known to have raced classified as “LMP” in some form since 1999.  There may be future modifications to the list.  Not all cars listed will allow the direct fitting of a FC-130 type motor without the use of a motor adaptor, the replacement of the chassis with a 3D printed type, the replacement of the motor pod, and/or modifications or replacement of the interior.)

Motors – any non-high downforce FC-130, Flat6, and/or FK-180 motors up to 22k (Note: may be run configured as anglewinder, in-line, or sidewinder)

            Motor Downforce – maximum 35 grams

Build rules – cars may be upgraded with any manufacture’s axles, bushings, gears, tires, wheels, and other parts including chassis (stock & 3D printed), motor pods, and interiors.  Motor adapters may be used to fit a FC-130 type motor to locations where a boxer (FK-180) or SCX type motor would have been normally been installed.